7.5-inch E-Ink Paper display HAT for Raspberry Pi Volcano hot end Heater Block/Heating Block for 3D Printer Deploy multiple FIO boards with

Deploy multiple FIO boards with XBee modules and environmental sensors (temperature

For applications involving hazardous or corrosive liquids

Low-profile design with optimized center of gravity for enhanced stability during high-speed maneuvers and obstacle navigation

The maximum safe load capacity is approximately 500-750 grams when the boom is fully extended

L293D Motor Driver Module (1 unit)

7.5-inch E-Ink Paper display HAT for Raspberry Pi Volcano hot end Heater Block/Heating Block for 3D Printer Deploy multiple FIO boards with7. 5 inch E Ink Paper display HAT for Raspberry Pi 7. 5 inch E Ink Paper display HAT for Raspberry Pi This is an E Ink display HAT for Raspberry Pi, 7. 5 inch, 640x384 resolution, with an embedded controller, communicating via SPI interface. This display shows the data on the screen as same as it seen on printed paper. There is no backlight so it can keep displaying last content for a long time even when the power is down. As these displays have no